This is the 1:10 scale electric powered, radio controlled,
Associated RC10 B4.1 Factory Team Off-Road buggy kit.
FEATURES: Chassis: Molded composite bathtub style Drive: Two
wheel with CVA drive shafts with pin retainer clips with steel center-drilled
front axles Transmission: 2.6:1 laydown type, high-torque capacity Ball
Bearings: Full set, 14 rubber sealed Shocks: Fatory Team V-2 oil-filled hard
anodized threaded with bleed screw caps, 30 weight silicone shock oil, Factory
Team blue aluminum shock bushings and pivot balls Dog Bones: MIP CVDs
Differentials: Ball type with lightweight outdrives Spur Gear: Plastic, 81
tooth, 48 pitch Front Tires: Pro-Line M3 4 rib inner diameter: 2.2" (55.88mm),
1" (26mm) wide with foam inserts Rear Tires: Pro-line M3 Holeshot high traction,
outer diameter 3.15" (80mm), inner diameter 2.2" (55.88mm) with foam inserts
Wheels: Yellow dish front; diameter 2.2" (55.88mm), width 0.87" (22.31mm), rear;
diameter 2.2" (55.88mm), width 1.42" (36.08mm) Body: Pro-Line Vortex with wing
Caster: Adjustable, caster/toe-in refers to the angle of the front suspension
when viewed from the side of the car in relation to the chassis Camber:
Adjustable, camber refers to the angle of the tops of the tires from vertical
when viewed from front or behind vehicle Toe-In: Fully adjustable, with titanium
turnbuckles, toe-in describes the angle of the front tires as viewed from the
top Suspension: Optimized for use with LiPo batteries, mounts for 4°, 3.5°, 3°,
and 2.5° rear toe Turnbuckles: Factory Team blue anodized titanium turnbuckles
Front axles: Steel center drilled Steering: Angled-bellcrank design to minimize
bump steer and maintain constant steering angles throughout the range of
suspension travel Forward-swept front end design provides maximum front end
ground clearance Servo saver: Built-in with aluminum servo saver bolt and heavy
duty spring Battery Strap: Carbon fiber with blue aluminum thumb screws
INCLUDES: Associated RC10 B4.1 Factory Team Off-Road buggy
kit, clear Pro-Line Vortex body with wing, decals, tires, wheels, shock oil and
instruction manual
REQUIRES: Radio: Two-channel with high-speed servo Radio
Batteries: (8) AA size Pinion Gear: Number of teeth to be determined by motor
Motor: 540 size for buggy applications Battery: 6-cell NiMH with standard
connector OR 2S LiPo battery Battery Charger: To match selected battery Building
and track equipment
SPECS: Vehicle; Length: 14.8" (377mm) Width: 9.8" (250mm)
Weight: 3.4lbs (1530g) running weight will vary depending on parts installed
Wheelbase: 10.7" (273mm) Internal Gear Ratio: 2.6:1 Body: Length: 11.3" (287mm)
Width: 5.5" (140mm) Height: 2.9" (73mm)